Moxa Technologies CP-104UL Manual de usuario descargar pdf (Pagina 15)

Hardware Installation

The installation of the Smartio CP-104UL board involves both hardware and software.

Software installation is discussed in the next chapter. In this chapter, we discuss hardware

installation.

The no-switch-no-jumper

Smartio CP-104UL board’s IRQ number and I/O addresses are

assigned automatically by the PCI BIOS. For this reason, the board MUST be plugged in

before installing the driver software.

Installing the Smartio CP-104UL board

Step 1: Power off the PC.

Warning! To avoid damaging your system and board, make sure your PC’s

power is switched off before inserting this or any other board into

an empy PCI slot.

Step 2: Remove the PC’s cover.

Step 3: Remove the slot cover bracket if one is in place.

Step 4: Insert the

Smartio CP-104UL control board firmly into a free 32-bit PCI slot.

Step 5: Fasten the holding screw to fix the control board in place.

Step 6: Replace the PC’s cover.

Step 7: Power on the PC; the BIOS will automatically set the IRQ and I/O address.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 62 63

Sin comentarios

Moxa Technologies CP-104UL Manual de usuario Pagina 15